Merge branch 'feature/pcnt_interrupt_priority' into 'master'

feat(pcnt): support set interrupt priority

Closes IDF-7953

See merge request espressif/esp-idf!25305

docs/en/api-reference/peripherals/pcnt.rst

@@ -46,6 +46,11 @@ To install a PCNT unit, there's a configuration structure that needs to be given
 
 -  :cpp:member:`pcnt_unit_config_t::low_limit` and :cpp:member:`pcnt_unit_config_t::high_limit` specify the range for the internal hardware counter. The counter will reset to zero automatically when it crosses either the high or low limit.
 -  :cpp:member:`pcnt_unit_config_t::accum_count` sets whether to create an internal accumulator for the counter. This is helpful when you want to extend the counter's width, which by default is 16bit at most, defined in the hardware. See also :ref:`pcnt-compensate-overflow-loss` for how to use this feature to compensate the overflow loss.
+-  :cpp:member:`pcnt_unit_config_t::intr_priority` sets the priority of the timer interrupt. If it is set to ``0``, the driver will allocate an interrupt with a default priority. Otherwise, the driver will use the given priority.
+
+.. note::
+
+    Since all PCNT units share the same interrupt source, when installing multiple PCNT units make sure that the interrupt priority :cpp:member:`pcnt_unit_config_t::intr_priority` is the same for each unit.
 
 .. only:: SOC_PCNT_SUPPORT_ZERO_INPUT
     

docs/zh_CN/api-reference/peripherals/pcnt.rst

@@ -46,6 +46,11 @@ PCNT 单元和通道分别用 :cpp:type:`pcnt_unit_handle_t` 与 :cpp:type:`pcnt
 
 -  :cpp:member:`pcnt_unit_config_t::low_limit` 与 :cpp:member:`pcnt_unit_config_t::high_limit` 用于指定内部计数器的最小值和最大值。当计数器超过任一限值时，计数器将归零。
 -  :cpp:member:`pcnt_unit_config_t::accum_count` 用于设置是否需要软件在硬件计数值溢出的时候进行累加保存，这有助于“拓宽”计数器的实际位宽。默认情况下，计数器的位宽最高只有 16 比特。请参考 :ref:`pcnt-compensate-overflow-loss` 了解如何利用此功能来补偿硬件计数器的溢出损失。
+-  :cpp:member:`pcnt_unit_config_t::intr_priority` 设置中断的优先级。如果设置为 ``0``，则会分配一个默认优先级的中断，否则会使用指定的优先级。
+
+.. note::
+
+    由于所有 PCNT 单元共享一个中断源，安装多个 PCNT 单元时请确保每个单元的中断优先级 :cpp:member:`pcnt_unit_config_t::intr_priority` 一致。
 
 .. only:: SOC_PCNT_SUPPORT_ZERO_INPUT